close
close

Diy Deadlift Platform 4X8

Diy Deadlift Platform 4X8. Built an easy two piece 4×8 deadlift platform for my 10×12 tuffshed! I cut them to 60”, hit them with the table router, and sand them.

How to Build a Weightlifting Platform The Art of Manliness
How to Build a Weightlifting Platform The Art of Manliness from www.artofmanliness.com

About 10 screws evenly spaced around the outside edge of the sheet is all that you need. I was womdering if it's viable to just make two 2×2 3layer mobile platforms. Effectively decreasing rom by about 2.25.

Cut If You Need To, And Place The First Layer Of Plywood/Particle Board.

Screw them in using the proper screws (1 1/2” for 2 layer, 2” for 3 layer). Newly constructed 4×4 diy deadlift platform. Building a lifting platform is relatively cheap and ridiculously easy.

You Could Opt From Something That Is A Little Lower In Cost And Not Sacrifice Usability.

If you’re building them like ours, you’ll only need 4 screws and washers per mat. My suggestion to anyone who wants to build the larger 8’x8’ platform for their basement gym, bring all the pieces down after doing the cuts and assemble it in the basement. You don’t need advanced handyman skills to complete the project.

See also  Free Guy Streaming Platform

Below Is How To Do It.

New (suggested) no comments yet. Log in or sign up to leave a comment. Make sure the wood is sturdy enough.

And There Is Very Little Equipment Involved.

New (suggested) level 1 · 3y. I have a question about building a platform, and reviving this old thread seams like a good place to start. My suggestion to anyone who wants to build the larger 8’x8’ platform for their basement gym, bring all the pieces down after doing the cuts and assemble it in the basement.

Portable Diy Deadlift Platform Suggestions There’s Plenty Of Diy Deadlift Platform Ideas On The Internet But Very Few Of Them Are Portable.

Cut the 4×8 plywood into 3×8. A lifting platform will elevate you off the floor by two inches. $197.44 (ish) i already had the stall mats.

Leave a Reply

Your email address will not be published.